Most towing advice is about the van's tyres. This post is about the other four: the ones on the car doing the pulling. For the van's side, see the caravan tyre pressure guide.
Why does towing change the car's tyre pressure?
A hitched van doesn't just roll along behind you. It pushes down on the tow ball. That downward weight is the ball weight.
The tow ball sits behind the car's rear axle, so the rear tyres take that weight. The ball acts like a lever: the rear axle gets heavier and the front axle often gets a little lighter.
A tyre needs more pressure to carry more load. That's why the right pressure for a car on the school run isn't always the right pressure with a loaded van on the back. The load and speed ratings guide explains how a tyre's load capacity is rated.
Which figure on the placard should you use?
Your car's tyre placard is usually on the driver's door jamb. If it isn't there, check the fuel filler flap or the glovebox.
Read it closely. Most placards list more than one figure:
- Normal load: for everyday driving.
- Full load: for a car carrying its full load. Some placards also mention towing.
- Front and rear: many vehicles list different figures for each axle, especially utes.
When you tow, use the full-load or towing figure, and follow the front and rear split. If your placard doesn't say which figure suits towing, check the owner's manual or ask the car maker.
The figure moulded into the sidewall is the tyre's maximum pressure. It isn't a target.
When should you set the car's tyres?
Set them cold, before you've driven more than a couple of kilometres. Placard pressures are cold pressures. Here's how to check tyre pressure with a gauge.
If you drive to collect the van from storage, set the pressures before you leave home. Or let the tyres cool before you adjust them.
Once you're rolling, the readings will climb. That's heat, and it's normal. Never let air out of a hot tyre to get back to the placard figure. More in how temperature changes tyre pressure.
When the van comes off and the gear comes out, set the tyres back to the everyday figure, cold.
How do you know what the car is really carrying?
The placard assumes a load. Your rig might carry more than you think once the van, the gear and the people are on board. A public weighbridge shows you.
- Load the car and the van exactly as you travel.
- Hitch up. Pull forward until only the car's wheels are on the bridge, with the van's wheels off it. That reading is the car plus the ball weight.
- Unhitch with the van off the bridge, then weigh the car on its own. Without a weight distribution hitch, the difference is roughly your ball weight.
- If the weighbridge gives axle-by-axle readings, ask for them hitched. They show how much the rear axle picks up.
- Check the numbers against the limits in your car's owner's manual and on the towbar's rating label.
Use a weight distribution hitch? Weigh with it set up the way you tow. It moves some of the load around, so the readings change.
Our post on caravan tyre pressure by weight covers weighing the van itself, and what the tare, ATM and GTM readings mean.
What if your tyres aren't the ones on the placard?
The placard is written for the tyres the car was built with. If you've fitted different tyres since, such as light truck (LT) tyres, the placard may not suit them.
A different tyre can need a different pressure to carry the same load. If you've changed tyre size or type, ask the tyre maker or a tyre shop that works on tow vehicles. Give them your tyre size, the load index from the sidewall and your weighbridge figures.
How do you watch the car's tyres while you tow?
A cold check sets the pressure. It can't tell you what happens 200 km later. Your car's own TPMS may not watch the van at all, as covered in can your factory TPMS see your caravan.
A standalone TPMS puts the car's tyres and the van's tyres on one screen. You see live pressure and temperature for each tyre and can compare them side by side. It warns you early when a tyre drops or runs hot.

For a car and a single-axle van, the Aura A6 Tow Pack watches all six tyres for $249, with a booster in the box. Its low-pressure alarm is adjustable.
A TPMS is an extra set of eyes. It does not replace checking your tyres by eye and with a gauge before you drive.
What should you do before your next trip?
- Find the full-load or towing figure on your car's placard.
- Set the car's tyres to it, cold, front and rear.
- Set the van's tyres too.
- Look over all the tyres for cuts, bulges and wear. Our pre-trip tyre check walks through it.
- Weigh the rig when the load changes.
Counting tyres for a monitor? Use Find my kit to match one to your car and van.
Questions
Should I pump the car's tyres to the sidewall maximum when towing?
No. The sidewall figure is the tyre's maximum pressure, not a target. Use the full-load or towing figure on your car's placard, set cold.
Does my car's own TPMS watch the caravan's tyres?
Usually not. Factory systems are usually set up for the car's own wheels. Check your owner's manual to be sure.
How many TPMS sensors do I need for a car and caravan?
Four for the car, plus one for each van tyre. A single-axle van makes 6 and a tandem makes 8. Add your spares on top.
Do the car's front tyres need more air when towing too?
Follow the front and rear figures on your placard for a full load. The ball weight lands mostly on the rear axle, which is why many placards list a different rear figure.
Not sure what your rig needs? Email us your rig: info@flatmate-tpms.com




